How Should this be alligned ? (picture)

[Eriksson]

The allingment was over the plastic bit, 3-4 mm off center where the marking on the housing is.

Should the marking on the housing be allingned tothe centerif the rotor arm ??

[martinjs]

There should be a mark on the hall sender cover where the green line is in this pic. Line that up with the mark on dizzy housing.

[Eriksson]

and the rotor arm how sould it be placed ?

[twoqu]

Hi!
At TDC the dizzy should align like this!

[Eriksson]

Many tnx mate!

Will post my project thread tomorrow.

CHEERS Pelle

[Eriksson]

i have one small problem the rotor arm and the line is impossible to gett in line with the line on the housing.

its the same as before now 3 mm off.

Is it possible to adjust the inner "line" ???

[Corey]

You see the round rivet (about 4 o clock in your image) over the cover for the dizzy clamp, remove that cover and there is a nut underneath. Undo the nut and rotate the dizzy till the lines align.

[Eriksson]

Okey.

Is the dizzy the outer housing or the inner ?
My car run well with apperently the Ignition a bit of ??!?