Boost Issue - RS2 ADU Engine

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • steverrquattro
    S2Forum Maniac
    • Oct 2006
    • 787
    • Country: England

    #1

    Boost Issue - RS2 ADU Engine

    I had a thread on here, but can't easily find it since moving over to the new system. Basically I bought some chips, fitted them and the car starts to come on boost and then just dumps it.

    I've chaged all the main pipes and vac hoses etc, POS and coil packs. I've pulled the codes and there is nothing stored, so I am suspecting the chips that I bought.

    The engine and ECU are original RS2 and I want a chip set for 395 BHP. Does anyone have a set, or is there anyone who can map the car?
    Steve

    1990 RR 20V
    1982 SWB UR - RS2 Engine

  • UrS4boy
    S2Forum Obsessed
    • Feb 2006
    • 11859
    • Country: Canada

    #2
    Originally posted by steverrquattro
    Basically I bought some chips, fitted them and the car starts to come on boost and then just dumps it.
    Sounds like you have a boost leak.

    ABY Boost leak testing:






    RS2'd 93 UrS4 5 spd sedan
    94 UrS4 V8 6 spd manual avant

    Comment

    • newsh
      S2Forum Obsessed
      • Aug 2003
      • 16226
      • Country: United Kingdom

      #3
      A boost leak leading to fuel cut would normally throw up an adaptation code.

      S2 Coupe 3B Project


      Ur quattro restoration

      S2 Avant

      Boost is the new rock and roll!
      sigpic

      Comment

      • UrS4boy
        S2Forum Obsessed
        • Feb 2006
        • 11859
        • Country: Canada

        #4
        Originally posted by newsh
        normally .
        Correct. Normally.
        RS2'd 93 UrS4 5 spd sedan
        94 UrS4 V8 6 spd manual avant

        Comment

        • rs200
          S2Forum Extremist
          • May 2009
          • 1398
          • Home: Croatia

          #5
          I had a boost leak on wastegate valve.. without any fault codes or fuel cut !
          try to blow air into wastegate lower chamber !

          on my stock AAN (stock 230HP) I have how problem with boost but it is something strange because it can only get 0.9BAR !
          what can cause that ???
          Iv check everithing.. 4 times boost leak test.. MAF, IAT,TPS,ECU,ISV, DV ..
          what else ?

          Comment

          Working...