The headlamp washers are on a different pump to the windscreen washers. You can get to it from the front just behind the bumper.
Ben
Ben
-
the best intentions are fraught with disappointment - gil grissom
sigpic
1994 ABY Avant - it's getting there -
So this means that i should be fairly easy to mount two nozzles on the fog lamp system and then i should be running?
/JonasComment
-
That's what I will be doing when I get around to it. My avant hasn't got the washers on the front so the pump is all ready to plumb in.
I just need to get some jets sorted out.
Benthe best intentions are fraught with disappointment - gil grissom
sigpic
1994 ABY Avant - it's getting thereComment
-
Yeah well my s2 does not have the fog lamp washer either since the previous owner removed them, so i guess it should be fairly easy setting up the system. Does the fog lamps have to pumps or one pump with a splitter?
/jonasComment
-
It's one pump. There is a tee piece that splits it between the two jets. (see picture)
It would probably be easiest to put a new pipe of the pump with a tee piece if your using more than one jet.
Benthe best intentions are fraught with disappointment - gil grissom
sigpic
1994 ABY Avant - it's getting thereComment
-
Well this means that there is only one pump to drive the IC jetz and the 2 front windscreen jets!?Comment
-
No, the other pump for the windscreen isn't shown on this diagram. Unfortunately ETKA uses generic diagrams for most things so they are not that accurate.
On this diagram the windscreen washer pump is number 9a (circled).
The others part circled (5b and 7a) are where the headlamp washer pump would go.
Hope this makes things a bit clearer,
Benthe best intentions are fraught with disappointment - gil grissom
sigpic
1994 ABY Avant - it's getting thereComment
-
Yes i get it know, the other drawing just confused me
Thx a lot!
How do i get that Etka catalog?
/JonasComment
Comment