Drawing of turbo oil return pipe flanges or gasket

[Jonas_R]

Does anybody have a drawing of the turbo oil return pipe flanges or gasket?

My pipe seems to be leaking and I was planning to make a couple of bungs so I could pressurerize the hose to see if it is leaking.

[AndyP]

I have them, do you want them in a CAD format of a PDF?

[Jonas_R]

I would prefer cad

[AndyP]

Email sent

[Error404]

I can make you some if required

[Rusty]

Have you replaced the bolts? I found out that the bolts on the underside of the turbo are M6x18 and when doing my enine rebuild and replacing everything with stainless, I had fitted 20mm bolts, which had bottomed out in the blind thread... £1.05 for 5x M6x18, 10 mins to replace and a drive to work and back later... and no more leak.

[Jonas_R]

I can make you some if required

I will 3d print some at work

[Jonas_R]

Have you replaced the bolts? I found out that the bolts on the underside of the turbo are M6x18 and when doing my enine rebuild and replacing everything with stainless, I had fitted 20mm bolts, which had bottomed out in the blind thread... £1.05 for 5x M6x18, 10 mins to replace and a drive to work and back later... and no more leak.

I had new OEM bolts but I will double check just to be sure.

[Jonas_R]

Thanks for the drawings.

My testing bongs

pressure_bong1.jpg
pressure_bong2.jpg
pressure_bong3.jpg