Drawing of oil feed gasket/flange for K26 turbo?

[Jonas_R]

I'm fitting a K27 turbo and the oil line is a bit thight to be honest, so I want to make a smaller space so I can move the oil line a bit away from the compressor housing.

Does anybody have a drawing of the oil feed gasket/flange?

Thanks

[Error404]

I have billet -4AN flange adapters if that helps?

[Jonas_R]

I don't really want to change to AN, just want to make a small flange that is 2-3mm thick to move the oil pipe at bit upwards.

if you have that then I would be interested

[Error404]

Pm me your email I can send you a file

[Jonas_R]

Thanks

PM sent

[Jonas_R]

Error404: did you get my PM?

[Error404]

Sent you an email today Jonas