Announcement

Collapse
No announcement yet.

Loom from firewall and ABS unit

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Loom from firewall and ABS unit

    Hi guys
    The cableharness that goes to the ABS unit has been cut , i think its to the ABS unit , does it go to a connector of some sort ? And is hthe connectors still around ? I want to mount get the ABS back again.
    Se picture.

    The harness that comes from the firewall , the upper hole , the 2 fat red cables has been extended , original its one brown and on red fat cables.
    What is the connector with 3 holes ?
    What is that connector for thats below the 3 hole connector ? Its plastic.

    Best regards
    You do not have permission to view this gallery.
    This gallery has 2 photos.

  • #2
    From memory, three pin plug goes to thermo switch bottom of radiator. The black plastic plug is your outside temperature sensor. Not 100% sure but other could be horn.
    I may have some old loom bits in the garage and possibly the abs bits. I will have to check tomorrow.
    Nothelle S2 Avant
    Black Ur project
    Ocianic Ur project gone
    S2 Coupe project gone
    Urs6 plus project gone

    Comment


    • #3
      Aha ,, ok ,, so the 3 hole contact goes to bottom of the radiator ,, where does the water temp on the dashboard take its values ? Is that the connector ? The fater 2 cables ,, red and braun is the question will have to follow them

      Comment


      • #4
        You do not have permission to view this gallery.
        This gallery has 1 photos.

        Comment


        • #5
          Where does those vacum line go ? They are cut of

          Comment


          • #6
            That vacum from cabelharness hole , its cut of ,, original it goes to ?
            You do not have permission to view this gallery.
            This gallery has 1 photos.

            Comment


            • #7
              There is a good vac pipe schematics on the forum if you have a search. They are all colour coded.
              The two thicker cables you have there probably go to the alternator or maybe the fan resistor plate?
              If you examine your loom carefully, you will find that when laid out it will take a natural course in the engine bay with bends in the correct places and marks where the retaining straps once were. I had the same problems rebuilding mine as I didn't take it apart and there weren't any readable markings. Lay it all out and most of the wires will find the correct path
              Nothelle S2 Avant
              Black Ur project
              Ocianic Ur project gone
              S2 Coupe project gone
              Urs6 plus project gone

              Comment


              • #8
                The vac hose in your last post could be to/from the diff lock actuator

                Comment


                • #9

                  S2 Coupe 3B Project


                  Ur quattro restoration

                  S2 Avant

                  Boost is the new rock and roll!
                  sigpic

                  Comment


                  • #10
                    https://forums.quattroworld.com/s4s6/msgs/188845.phtml

                    S2 Coupe 3B Project


                    Ur quattro restoration

                    S2 Avant

                    Boost is the new rock and roll!
                    sigpic

                    Comment


                    • #11
                      Originally posted by Tractor Dave View Post
                      From memory, three pin plug goes to thermo switch bottom of radiator. The black plastic plug is your outside temperature sensor. Not 100% sure but other could be horn.
                      I may have some old loom bits in the garage and possibly the abs bits. I will have to check tomorrow.
                      Have had any luck with the connector for the ABS unit ?

                      Comment


                      • #12
                        Sorry, I forgot about this. I will check for you tomorrow
                        Nothelle S2 Avant
                        Black Ur project
                        Ocianic Ur project gone
                        S2 Coupe project gone
                        Urs6 plus project gone

                        Comment


                        • #13
                          I’ve had a look this morning and I can’t find it. I have almost three cars in bits stacked up in boxes so it’s a bit difficult to find specific parts. I know I had the loom to the abs pump but can’t remember if it had been cut. Sorry, not much help an I. If it turns up, I will let you know.


                          Sent from my iPhone using Tapatalk
                          Nothelle S2 Avant
                          Black Ur project
                          Ocianic Ur project gone
                          S2 Coupe project gone
                          Urs6 plus project gone

                          Comment

                          Working...
                          X