Part number for 3b coupe coolant hose bulkhead bleed screw one.

[Condor]

Does anyone know the part number for the coolant hose with the bleed screw in ( for 3b coupe,at the bulkhead to heater matrix) I'm guessing it's no longer available from Audi?, is there a replacement hose with the bleed screw in it? The bleed screw on my 3b coupe was leaking slightly so something had to be done, this resulted in the nut which the bleed screw goes into detaching from the hose, I've done a temporary fix with a largish bolt but I want to fix this properly.. If I have the oem part number I can cross ref if needed.. Has anyone found a single silicone hose to rectify the problem I now have? Or has anyone found a good sealer to seal a bolt soundly in the hole where the bleed screw was? Thanks in advance ..Al////.....

[Bowie69]

There is a set of silicone hoses available for the S2 with a built in bleed screw, but not available separately IIRC.

[Tractor Dave]

I may have one

[Tractor Dave]

I have this but can't remember what it came off.



Sent from my iPhone using Tapatalk

[K Simmonds]

That looks like the one from my NG Coupe, with a short M8 bolt forced in to replace the snapped off the original plastic part, don't think it is the same one though. Samco have a bleed screw on theirs, just not sure it's available seperatly.

Don't think the OE part is avaiablle any longer.

[Condor]

I may have one

Hi Tractor Dave,just seen you put up a pic, is it for a 3b coupe yes??..it looks similar but difficult to see mine ..How much do you want for it? Cheers for now Al////.....

[LHD_Kid]

Roose Motorsport might sell you a seperate hose... worth a call...

[Tractor Dave]

Hi Tractor Dave,just seen you put up a pic, is it for a 3b coupe yes??..it looks similar but difficult to see mine ..How much do you want for it? Cheers for now Al////.....

I can't remember what it came off. You cover post and it's yours.

[Condor]

I can't remember what it came off. You cover post and it's yours.

Hi Tractor Dave, I guess the original nut came out from the hose, is the bolt just screwed into the rubber of that hose? ..I'm going to see if Roose or Samco will supply a single hose,I'll get back to you.. Thank you and others for taking the time to help ..most appreciated... Al////

[Condor]

A big shout out to Paul of ROOSE MOTORSPORT who soon replied to my emails and I got the coolant hose with a bleed screw the next day after I’d bought it. Thanks to the others on this post too who took the time to give suggestions etc .. I’ve still got the bolt in the old hose atm, it’s a bit tight to get the new hose on at the bottom ?.I need to be in the mood to scrape my knuckles ?.. .