Rotor arm BOSCH number urgently needed

[auditude]

It's possible to file the wider rotor down to the correct width. I haven't tried it myself, but it should be fine.

[kwlw]

It's possible to file the wider rotor down to the correct width. I haven't tried it myself, but it should be fine.

You don't need to file whole rotor arm (you would have balancing problems then) - just the copper part. Just cut ends with sharp file, or metal saw blade. 5 minute job.

Sau

[steverrquattro]

I followed the advice of this thread and still ended up with a rotor arm which measured 18mm!!! Having said that, I did get it from GSF.

They have now given me one from a Mercedes which measures 10.65mm. The question is, will this be too small???

Link to part: http://www.gsfcarparts.com/922me0030

[Pirvu Eugen]

http://www.ebay.com.au/itm/1x-Bosch-...ht_2049wt_1195

[Pirvu Eugen]

look here... it shows the right pn from the rotor.... i ordered this and i receive'd the right one... hope this helps! http://www.google.ro/imgres?q=123433...26&tx=36&ty=40

[Pirvu Eugen]

I followed the advice of this thread and still ended up with a rotor arm which measured 18mm!!! Having said that, I did get it from GSF.

They have now given me one from a Mercedes which measures 10mm. The question is, will this be too small???

Link to part: http://www.gsfcarparts.com/922me0030

It has to have smaller tip for the high rpm...to reduce the spark hop issues.
Iff the mercedes one has 1kohm resistor...then is ok..

[steverrquattro]

The BOSCH number on the BERU part is 1234 332 215.

[stocious]

toyota one in mine , but it most likely wont be in stock if you go to a stealers.

[AndyP]

For reference, these are available again from Bosch, but the rotor arm has gone up in price considerably!

1234 332 414 Rotor arm £16.49
1235 522 405 Dizzy cap £16.38