Loom problems

[Azman]

Right then guys. At a loss now!!!!

Can't seem to get them working for love nor money!!!

Anyone in the area willing to pop over and lend a fresh set of eyes for a few mins?????

Really doing my head in and I don't want to put the interior back together just in case it is possibly more serious than first expected.

Either that or get an Auto elecy on it???

HELP!!!!

[Jaap]

Hmm

How many connector did you connect on the loom where the instruments are??
i hope 2
Please connect the wire to the oil pressure sender on earth and check if the meter drops.
If it does, is the sensor no good.
Else you can messure on that wire, when not connected a voltage differace from 8-12V. to earth (-).(direct current)
If you don´t mesure that differance the wiring to gouches is no good.

[Azman]

We connected two, A two pin long connector (black) and a block connector (can't remember how many pins there are in it but it is a few.

I have tried swapping round the conenctors a few times for the tree pins ( two on the big snsor and one on the small. I don't seem to be getting anywhere with them. The loom has been remade and continuity tested . Is it worth just taking a cable length from the back of the connectors to the sensors themselves to see if there is any change.....

This is a pain!!!!!!
Cheers for all the help matey. I owe you a beer

[Azman]

And I have to go to work now too