Timing belt change

**martinjs** · 26 February 2004, 21:43

David the 3b tensioner/idler pulley is different to aby, id reccomend renewing the bolt for it also.

**s2driveruk** · 27 February 2004, 07:39

Managed to get some hose too Doug - i'll bring it along and a good selection of jub clips.

Martin - do you know what type of bolt is used on the pulley??? I can pop out to GSF or CAF if its a definate to change. Also what are the bolts for the water pump - got that to replace also but didn't think about checking the bolts

Cheers,

David

**martinjs** · 27 February 2004, 10:34

David, the bolt for the pulley is M6, think the length was about 40mm, cant make out etka drawing, could be either 35 of 45 long, best to get a long one, you can always cut it down.
the water pump uses M8 35mm long, dont think these are a must to renew, but it wouldn't hurt.

martin

**s2driveruk** · 27 February 2004, 11:34

Thanks Martin - yeah just though everything else was going in fresh so might as well change the bolts too.

David

Timing belt change

Comment

Comment

Comment

Comment