Refiting cams into head

[K7ERG]

I am looking for info on how the cams line up. I see there is to O marks. I am guessing timing marks. For the chain drive.

Can anyone tell me what needs done and what torque to put the cam caps.

Thanks in advance.

Craig

[dubmeister]

I assume you mean the AAN engine,
The '0' marks on each cam need to be lined up so they face each other when the exhaust cam pulley is lined up with its mark on the top of the cam cover (fit a new cam chain if its been removed)
Have a look at this: http://www.autotech.com/instructions/i109418.pdf

I know it is for a vw 16v but they are the same type of set up, Fig 2 will give you an idea.
Torque settings: Cam pulley- 65 Nm
Cam caps - 15Nm
Cam cover- 10 Nm
Hope this helps-Remember to turn the engine over by hand 2 turns to check for any resistance.
Good luck

[K7ERG]

Thanks just what i needed mate