Adjustable cam wheel - hall sensor friendly

[Billman]

I had something like this but they send me another one that is a bit better. Not perfect but better.

I was only seeing something visually. Haven't noticed that the belt goes slack and tight.

[G60Rallye]

They are sending me a new one now. I could live with a small bit off centre but not over 1 milimeter. If it is off centre you are bound to have a tight and slack spot on the cambelt. It will be on the non drive side so I am not sure how critical it is? Even so its a bad bit of machining and I am not happy to run it. I will let you know how much better the next one they send is!

[Thuppu]

I have a big issue with mine, which I hope will be sorted with no issues from Rosten.

The centre is machined a milimeter off centre. Only noticed it because the cambelt was going slack then tight whilst going through a 720 degree rotation.

When you turn the engine over on the starter its a long way out! Has anybody else had the same problem?

I did have the same issue. Read in my project thread. Got a new center piece from Geir, no problem. He told there have been a bad batch from the factory. The new one is perfect.

[G60Rallye]

I have just read through it all, and its a great project! Good to hear the new centre was spot on!

Geir has sent one in the post so hopefully it will be here soon!

[rs200]

when you use this adjustable cam gear , can you fit back timing belt cover?

I can't , so is there some on market which allow that?

thx