ABY Engine Harness/Loom Question

[terrybullwon]

Actually - I thought £150 wasn't so bad either in this crazy climate... I know its only a little section of cable...

If all the connectors were available from new I could easily make a clone of that lil loom - but for the time required to do a nice job and test it - it would be cheaper to just buy it.

Getting the right conectors Paul is a pita all right been there done it

[S2central.net]

I rest my case m'lud !

[terrybullwon]

Getting the right conectors Paul is a pita all right been there done it

I rest my case m'lud !

Even worse now come to think as i had martin (vag parts) get them for me and about 4 out of 10 were correct

[S2central.net]

The electrical sections of the family album are a total bloody shambles... My 7yr kid could do better.

When I looked up that part number off the sticker from the loom - it comes up listed for 'MPI' applications - doesn't even mention what engines its used on... And it is nearly impossible to find the right connectors. I could not source trustworthy info on wiring looms and connectors from that - no way...

[PeterS]

That little ABY extension loom with female termination at T8e and T8f does indeed have a sticker - 895 971 066 B (kinda gnarly to read actually)

The cylinder connectors as follows -

Female = 443 972 984 (2-required)
Male = 443 972 983 (2-reqd)
Hood = 443 906 102 F (4-req'd)


Paul

Interesting...
Found a stateside supplier with the following descriptions & prices:

443 972 984 Connector -$26.97 each
443 972 983 Housing $6.57 each
443 906 102 F Hood $7.86 each