rs2 timing belt changed, wont start!?

**Ross** · 17 April 2009, 14:39

Originally posted by S2central.net

Have you checked all the earth straps already ?

Is there a definitive list of earth locations? I've got the IM (X2), and block to chassis, cant find anywhere else... would be interested to know how many termination points there should be from the loom.

**adamw** · 17 April 2009, 17:51

no change yet, ive been holding off until i get the new belt. hopefuly tomorrow

cheers adam

**twoqu** · 17 April 2009, 18:19

I have always thought it was half a tooth off not one:

http://www.s2forum.com/forum/showthread.php?t=8661&highlight=rs2+timing

**adamw** · 30 April 2009, 22:05

i borrowed the hall sensor tester from lcsmith and tested it, sensor works fine. it still sounded like it was trying to fire on two cylinders, turned the key again and it spluttered into life!!
its idleing abit ruff and there is a slight tappet noise? there is good oil pressure (5bar)

any ideas?

cheers adam

**S2central.net** · 30 April 2009, 22:10

Adam - thats good it validates LCsmiths hall sensor is good - its his immo wiring doing the badness. For you I think it is a case of timing belt being out of kilter.

**adamw** · 1 May 2009, 06:38

hi paul

sorry but what is out of kilter? out of sync?

cheers adam

**Nuvo** · 1 May 2009, 07:42

Out of kilter means means "not working or adjusted properly".

rs2 timing belt changed, wont start!?

Comment

Comment

Comment

Comment

Comment

Comment

Comment