Sump baffle, check valves?

[gnutz2]

I'm trying to make the standard sump on my car a bit better but cannot find what i'm looking for.

They are small rubber flaps thet pop into place to let oil flow in one direction.

I know people use them in cosworth circles like this.

http://cgi.ebay.co.uk/Subaru-Coswort...A1%7C294%3A200

Anyone know where i can buy the rubber flaps from

[Error404]

I've got something like that as standard on my 7A Like a plastic plate with slots in it to stop opil spalshing up the crank case.
Can't see it in the FA though, i'll take a pic later its in my garage

[gnutz2]

That would be a great help, thanks.

I cant seem to find those rubber flaps anywhere on the web

[Flat on my back]

.

This...

or use the rs2 baffle?

[gnutz2]

I might have to make something like that if i cant find any of the check flaps.

I assume a RS2 sump is pre drilled and tapped for the baffle because i dont remember my ABY having the holes.

[quattro84]

I did see some foam inserts in high output rallycross cars. Take this spunge and sandwich it between 2 pieces of sheetmetal. Mill some straight slots into the sheets, or get loco with a drill.

I'd be cautious because of possible wear on the foam. On the other hand, race fueltanks are stuffed with something similar...

[gnutz2]

I did see some foam inserts in high output rallycross cars. Take this spunge and sandwich it between 2 pieces of sheetmetal. Mill some straight slots into the sheets, or get loco with a drill.

I'd be cautious because of possible wear on the foam. On the other hand, race fueltanks are stuffed with something similar...

Thats another good idea, thanks.

[Jamo]

Never seen this before! bit late now for my build

[Flat on my back]

.

RS2 sump baffle and gaskets.

[gnutz2]

RS2 sump baffle and gaskets.

Thats the same as the ABY baffle or windage tray.

[4WheelDrifter]

Same as the 3B too.

I have a couple of plastic 7A windage trays here. They don't have flaps on them, just louvres.

[Error404]

This...


or use the rs2 baffle?

thats what I was going to post a pic of - thats what i've got on my 7A.

[4WheelDrifter]

That is a 7A tray, not an RS2. The RS2 tray is the same as 3B, ABY and AAN.

Interestingly the RR is listed as having the same tray as the 7A. [edit] As well as the 3B from the 200 quattro Turbo.

[Error404]

Can you fit the 7A tray and the windage tray off the S2 / RS2 then i wonder?

[AndyP]

Can you fit the 7A tray and the windage tray off the S2 / RS2 then i wonder?

I hope so because thats what I'm using. I never realised that the plastic baffle was not from the S2, so I must have a 7A sump. It's already fitted with the windage tray from a 3B.