crankshaft balasing

[rs200]

hy...

the engine is 3B.
do I need to balansed the crankshaft before than I put all engine parts togheter?

i have new conecting rod (thanks to aromatic2) ,everything else is stock.

and I have one more question:
the pin on the back side of flywhell wich is importand for sensor can read a position of crankshaft, was broken and we patched this pin back on flywhell.

if this pin is not 100% on place like when was new,can they damaged the engine?
like bad ignition wrong start or something else.... the car was working on that flywhell ,but after 2 years ...booom.... can that be a reason for broken conecting rod.

thanks for a help !!!

sorry for my bead english!

igor

[lind4hl]

you dont need to balance it, but if you do, you should do it togheter with:

flywheel
clutch
and front pulley
the pistons needs to be same weight.
the rods needs to be same weight

[rs200]

everything is stock, only the rods are diferent but same weight.

thanks for information


do you know something about this pin on the back of flywhell??

[rs200]

i am talking about pin on page 9 ,"geber fur zundzeitpunkt" .

the litle pin on flywheel is not 100% in place. in my car.

can distributor give a wrong time spark because of this litle pin?

thanks for help!!!!!!

[rs200]

jea i finaly find a pitcure of my problem: crank position sensor read one litle pin and this pin is not 100% in place. is this a problem for wrong spark plug?

thanks

[S2central.net]

Crank position sensor needs a good signal then is generated by a pin in the inner side of flywheel at 62 degrees BTDC - a bad signal from that will give all sorts of trouble - maybe even difficult to start the engine actually.

[quattrostyle]

you dont need to balance it, but if you do, you should do it togheter with:

I always thought it was recomended to do so, even if only the rods are changed.

[rs200]

Crank position sensor needs a good signal then is generated by a pin in the inner side of flywheel at 62 degrees BTDC - a bad signal from that will give all sorts of trouble - maybe even difficult to start the engine actually.

the engine starts very well, I am so vory about this pin. they are not 100% in place. is it posible that this pin killed my stock conecting rod in engine?

[rs200]

I always thought it was recomended to do so, even if only the rods are changed.

if i will change the flywheel, i will must do the balansing .

is a 7A flywheel diferent than 3B? are thay the same or not?

[lind4hl]

i asked one person on VEMS aboout the 7a, he said that if i would use a 7a flywheel then i needed to change someting, dont remember what though, something electrical...

Quattrostyle: that is what i mean, you dont need to do it, but it is good if you do it..

[rs200]

to change something electrical????? yes it is diferent on your car because you have ADU and diferent flywheel. but in my case i think it is the same.

can someone find me a part number of 7A flywheel . thanks.