Which injectors?

[Quattro Dan.]

Can anyone recommend the injectors i need for the following set up;

injectors?
GT3071
rs2 exhaust manifold
044 motor sport fuel pump
scat rods
bigger than standard intercooler
AAN inlet manifold
2.75 inch exhaust- no cats
3 bar map sensor
mechanical boost- no WGFV:mischeif:

Also what sort of BHP should i get with this set up?

Thanks in advance,

Dan.

[s2_bo]

Siemens do some good ones at 660cc they are about £220 a set iirc, Audiman used to sell them.

Cheers.
bo

[Jamo]

probably just around 400 bhp, the 2.75 downpipe is may hurt you for backpressure at these bhp level.

Any injector 440cc would do you. Bosch greens etc best ones would be the ones Bo's said above

[AndyP]

http://cgi.ebay.com/ebaymotors/5-Bos...Q5fCarQ5fParts

These are what I'm using in mine.

[EBR]

I have 5 used Siemens Deka 580cc injectors. They are for sale if anyone is interested, you can pm me for more info.

Eiríkur...

[david]

http://cgi.ebay.com/ebaymotors/5-Bos...Q5fCarQ5fParts

These are what I'm using in mine.

are these just as good as Rs2 injectors?

[Jamo]

are these just as good as Rs2 injectors?

What so special about RS2 injectors...............

Nothing

[david]

rs2 injectors

nothing special,just a bench mark to gauge how good the injectors are

[Jamo]

Your logic is flawed the RS2 injectors are not special there is nothing to benchmark against. The only thing special about them is they were designed for a specific cc output for the RS2 chipset.

When looking for injectors for the S2 you want a) multi point spray pattern over single pattern b) High impedance to work with the stock ECU c) Enough cc to flow for your BHP application.

[AndyP]

Depends what you mean by good? They are a Bosch injector like the RS2 so they are the same quality, but slightly higher flow capacity.

[david]

i think you hit the nail on the head. better flow,that's what i was looking for

[nip]

dan, i have some siemens 440cc injectors if ur interested

[trackslag]

have a play with this look at bottom of page

http://www.emeraldm3d.com/em_how.html

[Jamo]

For the I5 engine it's even simpler injector cc equal bhp

[trackslag]

out of interest what size are standard ABY s2 injectoer anyone know?