Hi there,
Working on my 90Q and have a few questions regarding the conversion. Tonks, where are you when I need you?
1.Earth from coils - where should it go? The cable is about 100mm to short to reach anywhere, do I extend it?
2.Brake vacum/ servo - how do I get round that? My 90Q is vacum but the ABY is hydraulic? Can I tap into the IM?
3.Boost controller N75/ loom cable? - Wheres that little ******? Is it on the original ABY loom?
4.Earth from bottom of engine? Where does it fit? Not long enough.
5.90Q main wiring/ S2 ABY main wiring? Had a sniff round S2central and need some more wiring drawings, does anyone have any?
Many thanks
James
Working on my 90Q and have a few questions regarding the conversion. Tonks, where are you when I need you?
1.Earth from coils - where should it go? The cable is about 100mm to short to reach anywhere, do I extend it?
2.Brake vacum/ servo - how do I get round that? My 90Q is vacum but the ABY is hydraulic? Can I tap into the IM?
3.Boost controller N75/ loom cable? - Wheres that little ******? Is it on the original ABY loom?
4.Earth from bottom of engine? Where does it fit? Not long enough.
5.90Q main wiring/ S2 ABY main wiring? Had a sniff round S2central and need some more wiring drawings, does anyone have any?
Many thanks
James


Comment