fun time

[bernsaudi]

I have a 380hp rated turbo(that was on an ABY), ecu, injectors. If I bolt all this on, I assume my engine should perform. It already is up to 290 odd, and I have the 3inch miltek on already, but should I put rods in before doing this, or should the engine cope if driven respectfull of the change?
Ta!

[Greg_S]

Which turbo have you got? You will more than likely need a remap before you use the new turbo though.

[Acidburn]

speak to hoffer76 as he could help out here

[bernsaudi]

this one....

5326-101-5160

v.t 109-6

any ideas?

[hoffer76]

rs2 turbo or rs2 hybrid by the looks

[bernsaudi]

just found this number on the hotside.......
5326 101 6367

the aet plate has vt 109-6 on it.

[bernsaudi]

Am i right in thinking that if I bolt this onto my car now(it is mapped on a stock turbo to a good 290), it will run like a bag of the proverbial? I will need to get it mapped, so if you can help, thanks a lot :~)

[T2Andy]

you might want to change the fuel pump to a higher flow one , bosch 044 .

[bernsaudi]

Is it necessary to get rods, or can I take care with it do you think?

[20vQC]

dunno... the compressor side looks a bit small to be rs2. I can't find any turbo with those codes, it's from the k26 family for sure, with a weird and small exh side...even smaller than a mc2's k26 I think

[driftin jo]

dunno... the compressor side looks a bit small to be rs2. I can't find any turbo with those codes, it's from the k26 family for sure, with a weird and small exh side...even smaller than a mc2's k26 I think

mc2 is a k24

[T2Andy]

Rods should be ok ,theres many a mapped RS2 on standard rods ,its high tourque at low rpm that can bend rods ,also spark hop on the 3b engine ,i have 425 lb\ft on a k26 turbo and still going well on stock rods

[hoffer76]

cold side is same as rs2

below a pic of one of mine

[T2Andy]

and not driven respectivly ...

[bernsaudi]

so its injectors next then.....anyone got a set?