why do i have to use two dump valves?

[audiman]

LOL, same here

[timucin]

forge dv006

[91_S2]

Rich,

I placed it down low behind the side grill (RS2 bumper) in front of the oil cooler. This was too low, especially for the wet climate here. So now that I have it all apart again for the rebuild, I am going to place it higher up, I've taken the air-con compressor out so it will go where that used to be.

Mark.

Water was exactly what I was wondering about. Nice that we have you and Doug out there in front

[Josh-stateside]

Seemingly Dalback like's the HKS product for high boost applications.

Cheers
josh

[Josh-stateside]

I forgot to mention...


I also read that dalback changes the ecu to read "density" from the maf sensor vs "flow" for high boost applications. It was in this months european car.

Mihnea can you comment on this? Did I type that right?

thanks
Josh

[Albert]

i have taken out maf and signal is taken form map ... it works very good and I did not have to use exensive SQ maf for 4 inch inlet

[Josh-stateside]

i have taken out maf and signal is taken form map ... it works very good and I did not have to use exensive SQ maf for 4 inch inlet

Can you go into more detail about this albert? Stock Ecu wiring? Do you tune motronic yourself or did some one else do this for you?

Thanks
Josh

[Albert]

http://www.perfectpower.com/products/smt6.asp It is good for 3B
for aby You have to wait for http://www.perfectpower.com/products/smt7.asp