engine truble..

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • zlobo
    S2Forum Maniac
    • Jan 2004
    • 967
    • Country: Sweden

    #1

    engine truble..

    A friend of mine have some problem with his engine.

    The engine blow out oil through the breather.
    Does anyone know what may cause this???

    And he also have one other problem.
    Hes oil pressure is very low he has 1-1,2 bar at idle, and ~3bar over 4000rpm

    I tryed to replace the pressure release spring with no bigger diffrence.
    I dont know if the oil pump is bad or what may cause this. he is running with mobile 1 5-50 oil.

    Hes brother have dismountet the engine once. so i dont know if there is anything wrong whith the lower part of the engine. i know that the top is ok..

    Can any one help me with ideas?
    ABT C5 Lord Of The Rings
    2004 1/4 Mile ET 12.00 191Km/h @1,5Bar
    2009 1/4 Mile ET 11.92 213Km/h @ 1,5Bar 437WHp
    2010 1/4 Mile ET 11.45 110Km/h @ 1,5Bar 437Whp
    kostic.nu
  • audiman
    S2Forum Freak
    • Jul 2003
    • 4827
    • Country: United Kingdom

    #2
    Badly worn piston rings maybe. Do a compression test with 'dry' bores and then with 'wet' bores. See what the difference is.
    sigpic
    Tom C - www.rcmr.co.uk
    Audi UR Quattro
    Audi 100 C3 2.0 5 cyl 115ps
    Audi S2 - 07k engine project aiming for 800ps
    Audi B5 RS4 645ps 911nm

    Comment

    • zlobo
      S2Forum Maniac
      • Jan 2004
      • 967
      • Country: Sweden

      #3
      i did a comp test with a cold and warm engine, it was ok.
      ABT C5 Lord Of The Rings
      2004 1/4 Mile ET 12.00 191Km/h @1,5Bar
      2009 1/4 Mile ET 11.92 213Km/h @ 1,5Bar 437WHp
      2010 1/4 Mile ET 11.45 110Km/h @ 1,5Bar 437Whp
      kostic.nu

      Comment

      • audiman
        S2Forum Freak
        • Jul 2003
        • 4827
        • Country: United Kingdom

        #4
        try it engine warm but with a bit of oil poured into the bore. See if that makes the comp. higher.
        sigpic
        Tom C - www.rcmr.co.uk
        Audi UR Quattro
        Audi 100 C3 2.0 5 cyl 115ps
        Audi S2 - 07k engine project aiming for 800ps
        Audi B5 RS4 645ps 911nm

        Comment

        • zlobo
          S2Forum Maniac
          • Jan 2004
          • 967
          • Country: Sweden

          #5
          nearly the same comp if i dont did a mistake. hes broter replaced the pistonrings for about 4 months. dont know if its posible that he has fited the piston rings wrong?

          He also had 5bar of oil pressure when engine was cold befor now he only have 3bar.

          i am out of ideas. I dont want to tear the engine apart with out knowing whats wrong.
          ABT C5 Lord Of The Rings
          2004 1/4 Mile ET 12.00 191Km/h @1,5Bar
          2009 1/4 Mile ET 11.92 213Km/h @ 1,5Bar 437WHp
          2010 1/4 Mile ET 11.45 110Km/h @ 1,5Bar 437Whp
          kostic.nu

          Comment

          • audiman
            S2Forum Freak
            • Jul 2003
            • 4827
            • Country: United Kingdom

            #6
            Either the oil pump is failing or it may be due to excessive wear in the main/big end bearing shells. Were these replaced?
            sigpic
            Tom C - www.rcmr.co.uk
            Audi UR Quattro
            Audi 100 C3 2.0 5 cyl 115ps
            Audi S2 - 07k engine project aiming for 800ps
            Audi B5 RS4 645ps 911nm

            Comment

            • zlobo
              S2Forum Maniac
              • Jan 2004
              • 967
              • Country: Sweden

              #7
              nope they was not replaced.
              ABT C5 Lord Of The Rings
              2004 1/4 Mile ET 12.00 191Km/h @1,5Bar
              2009 1/4 Mile ET 11.92 213Km/h @ 1,5Bar 437WHp
              2010 1/4 Mile ET 11.45 110Km/h @ 1,5Bar 437Whp
              kostic.nu

              Comment

              • audiman
                S2Forum Freak
                • Jul 2003
                • 4827
                • Country: United Kingdom

                #8
                maybe pressure as dropped due to the wear in the bearings? Its hard to know without seeing the car. Are all the breather hoses clear? Eg no blockages in the hoses?
                sigpic
                Tom C - www.rcmr.co.uk
                Audi UR Quattro
                Audi 100 C3 2.0 5 cyl 115ps
                Audi S2 - 07k engine project aiming for 800ps
                Audi B5 RS4 645ps 911nm

                Comment

                • Mark Halligan
                  S2Forum Fiend
                  • Jul 2003
                  • 2001
                  • Country: England

                  #9
                  If one or more of the oil squirters (under the pistons) had worked loose the pressure would drop too.

                  Mark.
                  Mark - Modded

                  Comment

                  Working...