034 Main Bearings dont fit right.

[caterpillar]

if they doesnt fit; dont use them.....!!!!! send them back .its the only options!!!

[V6quattro]

Of course i don't take a risk at this expensive build

The are a couple things 034motorsport said i can do:

-Wait until the is a solution. (don't know what to think about that. Can take a long time.)

-Take a file and grind the edge so that the bearings fit. It should not create any issues. (I'm absolute not going to do that in a $10.000 engine built) Specially with a extreme clamp load pressure plate i use

-'Assuming you have not removed the bearings from the package or tried to install them, we can take them back and issue you a store credit for anything else you may need for your project, including all upgrade parts as well as all OE replacement parts' (This was the lest seclusion the give my. I'm little pist about this. Of course i have take them out of the package :corey


I'm very happy with the other products i'have bought at 034. Bud I'm a bit disappointed at the costumer support. I'ts now 9 days ago i email't them this problem and still there is not a good solution i think.

I just want good bearings. No more no less.

And if people from 034 reading this, can you answer my last email?