You can change the style the forum displays by selecting your preferred style at the bottom left of the site.
We have made an enhancement so that old threads should now link from search results to the correct thread. This is not yet in place for single post links
anyone know the correct PN for the G40 sensor, just spoke to my mate at VW and the part number he can find is 034 905 381 or 034 905 381A are any of these correct? I put the part number into google and it comes up as a crankshaft pulse sensor?
Check out this post (below) PN should be 034905161
The Audi Enthusiast website. Forums for all Audis including A4, S4, A5, S5, A6, S6, allroad, A8, S8, TT, R8, Q5, Q7, 4000, 100, 200, v6, v8, vintage, local forums
RS2'd 93 UrS4 5 spd sedan
94 UrS4 V8 6 spd manual avant
The signal output is on pin 2... thats the pin that should blink.
Pull back the rubber boot and ease LED pins down into contact with the connector leads on pins 2 and 3. Ignition on and you should see pulses from the LED if the sensor is ok.
You need to put a 5V LED (i got mines, a CJ65V, from maplins http://www.maplin.co.uk/Module.aspx?...rderCode=CJ65V ) across pins 2 and 3. The signal output is on pin 2... thats the pin that should blink. Pull back the rubber boot and ease LED pins down into contact with the connector leads on pins 2 and 3. Ignition on and you should see pulses from the LED if the sensor is ok.
Isn't this something that Paul N. has built as a plug and play tester?
In any event, Avants2turbo's immediate issue is his connector is busted up. That said, he *could* still just connect the appropriate wires and their male-female spade connectors together, keeping them from touching with PVC electrical tape.
RS2'd 93 UrS4 5 spd sedan
94 UrS4 V8 6 spd manual avant
Isn't this something that Paul N. has built as a plug and play tester?
In any event, Avants2turbo's immediate issue is his connector is busted up. That said, he *could* still just connect the appropriate wires and their male-female spade connectors together, keeping them from touching with PVC electrical tape.
do we really think that busted connector could stop the car from starting?
do we really think that busted connector could stop the car from starting?
If any of the three pins on the G40 are not working or are not connected properly, your engine is not going to start, end of story. As I suggested the plastic connector housing is not 100% necessary, if you were desparate and wanted to get the car started.
RS2'd 93 UrS4 5 spd sedan
94 UrS4 V8 6 spd manual avant
If any of the three pins on the G40 are not working or are not connected properly, your engine is not going to start, end of story. As I suggested the plastic connector housing is not 100% necessary, if you were desparate and wanted to get the car started.
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment