im almost done swapping the engine from my competition for a ABY with 6 speed but i have a problem. the engine sits to low, now i cant mount my FARB because its hitting the sump (7a sump). also the sump hits the subframe. are the engine mount from an rs2/s2 aby higher ? when im looking to the snub mount it seems that the engine need to lift 2 cm. anyone knows this problem ?
-
5 Cylinder Freak
-
are you using new engine mounts? If not they are probably collapsedPanthero Coupé quattro 20vt
Indigo ABY coupé
Imola B6 S4 Avant -
could that cause a 2cm height difference ? i will take a look5 Cylinder FreakComment
-
Your problem might be the gearbox mounts pushing the gearbox and rear of the engine too high, what subframe and rubber mounts are you using?91CQ20v - Gone to a new home
93UR-S4 - The Magic Carpet
94S2Bus - The Emerald ExpressComment
-
I have found that S2 engine mounts are taller than 1.8, 2.0, 2.3 and all typ85 engine mounts,
I suggest get a set of S2 ones should sort it
Comment
-
When i bougth engine mounts to my rs2.
There was different part no if you have aircondsion or not. (on oem mounts)
I dont know the difference.
I bougth 034 street densyti and my engine rised up about 10-15mm(so collapse is possible)
Hope this help
Comment
Comment