boost problem only on wot
Collapse
X
-
-
blocked off throttle housing boost hose to ecu and dv, pressure tested over 2psi very small leak from hose on back of inlet manifold , fitted new hose and clips again retested no leaks found with water spray soap, ran up the road slight improvement
problem is from 4000rpm up wards in gears does not pull hard like it does lower down with boost.1.2 max from here ,Comment
-
You blocked off the DV?
Don't, test with the DV in place, it might be leaking.
Also, you said 2 psi. Surely you meant 20 psi?
Comment
-
update
just fitted boost guage from rusty , checked all hoses again on rear of inlet manifold no leaks also changed original hose from green hard pipe to t piece yesterday just incase , now every pipe is new. 4th gear from 3000rpm 1.7 bar spike for 1 second , and then hold at 1.6 untill 5000rpm then drops gradually to 1.25 which is the best i have ever had the car running, BUT i have the same set up as avantus 1.9 bar max .
i can get the car to boost to 1.9 by pinching the boost hose which connects to the ecu
and it will hold there. so whats wrong ?Comment
-
So you still have not done a pressure test on your car? Or did you this time?
Pressurize the intake, also including all vacuum hoses.
Also pull codes and log altitude sender in VAG-COM.
Pinching the ECU hose you might make the ECU give more WGDC. Doing that with a car that is not boosting properly, although it should is the best way to blow up the turbo or worse.Last edited by prj; 9 January 2012, 12:02.Comment
Comment