Does anyone know where to get .25mm oversized rs2 bearings?
My project has been on hold for the last six months because of it .....
My project has been on hold for the last six months because of it .....
-
-
In the UK yes but not cheap they work out a lot more expensive than stock at around UK£260-80 the last time I checked from the KS distributor for just the mains and big ends no thrust washers. I try and avoid using them if there is a good crank available as normal ones are £220 including thrust washers.UrS6 Stroker + HTA3586 =
-
hmmm, already invested into a 92.8mm crank....Comment
-
anyone use ACL rod/main bearings?Comment
-
Found oversized Kolbenschmidt bearings in Germany!....phew
Comment
-
why oversized?Cranks are like speed bumps.You find one almost everywhere.
Almost any 10/20v 5 piston crank will fit.The old cranks are 2 oil holes(i think they are better than new 1 oil hole)
KS bearings should be around 180-200eur for both main and big end.If you are interested i can ceck for prices.Comment
Comment