Hi guys,
I have a temperature problem with Coupe Quattro KV Engine (5 cyl 10v).
I have bought and don't see temp problems but latter it appeared. I have changed water pump, transmission belts, radiator, coolant G12+, new radiator temp sensor and purged air (two screws, one at radiator and other at tube)
When it runs stopped, it puts at 90 + 2 steps. Starts the fan at the first run. Latter it increase until first point and fan runs some times at first run. If you move it at highway it runs at 90 + 2 steps. But if you go faster or do a more aggressive conduction it starts to increase above first point and coolant go out
When it occurs, the second run of fan don't start and I have checked that it runs if I make a point at sensors connector (sensor is new).
Coolant don't have burbles, oil and when engine stops and decrease temp, no pressure accumulation at circuit.
What could happen? I don't know what to do at these point
Some dirty part of circuit? It seems to have a very high temp part and other more low... or bad pressure... I don't know. 
Thanks in advance!
I have a temperature problem with Coupe Quattro KV Engine (5 cyl 10v).
I have bought and don't see temp problems but latter it appeared. I have changed water pump, transmission belts, radiator, coolant G12+, new radiator temp sensor and purged air (two screws, one at radiator and other at tube)
When it runs stopped, it puts at 90 + 2 steps. Starts the fan at the first run. Latter it increase until first point and fan runs some times at first run. If you move it at highway it runs at 90 + 2 steps. But if you go faster or do a more aggressive conduction it starts to increase above first point and coolant go out
When it occurs, the second run of fan don't start and I have checked that it runs if I make a point at sensors connector (sensor is new).Coolant don't have burbles, oil and when engine stops and decrease temp, no pressure accumulation at circuit.
What could happen? I don't know what to do at these point
Some dirty part of circuit? It seems to have a very high temp part and other more low... or bad pressure... I don't know. 
Thanks in advance!

Comment