Supertech piston clearance

[20Vcqdriver]

How many have used SUPERTECH pistons.
Managed to get a set from Rosten performance before website and Geir Rosten vanished.
The spec sheet says that the minimum clearance for these pistons is 0.07mm and have had mine set to 0.075mm, some are saying it should have been 0.085, but as supertech use an alloy with 18% less expansion than the likes of JE i should be OK but be interested to know what others using supertech have used. Cheers

[filip.krticka]

I'm going to use Supertech piston for 81,5mm diameter in my engine build as well. I have had set mine to 0.08mm.
BTW I have bought them from Rosten as well. According to the Geir gap should be ok.

[FCP-ENGINEERING]

Supertech writting 0,07mm it is minimum clearance good for dayli use, for drag racing circuit 0,08-0,085mm.

[20Vcqdriver]

Supertech writting 0,07mm it is minimum clearance good for dayli use, for drag racing circuit 0,08-0,085mm.

Should be OK then as not using them upto daft boost pressures (max will be 28psi) and for a road/show car with a bit of fun now and again.