Where do these hoses go?

[Colesy]

Have had the S2 in pieces and thought I'd fit the Samcos I had in the cudboard while I was at it. But can't work out exactly where these four hoses are supposed to go?

One has some sort of bleed valve on it, a few pics should help:





I realise I'm probably just blind!

[GazzaG60]

one with screw I presume for the heater matrix bleed.

other one for other side of matrix I think.

2 little straights look like "oh spares" "ill keep those in cases" hoses ??

[andyg plym]

dont forget the small hoses tucked underneath out of sight, ie thermostat housing and theres one above it tucked right under the inlet manifold

[mcandmar]

As above engine to heater matrix, as for the other two i think they are for the engine block coolant rails, trim to fit basically.

[LHD_Kid]

one with screw I presume for the heater matrix bleed.

other one for other side of matrix I think.

agreed, but the 2 straight are the ones tucked up under the IM...

[John B]

2 x heater matrix and 2 for under water rail (little b**gers they are too!)

Have a look at http://www.s2forum.com/forum/showpos...0&postcount=23

[Error404]

The fatter of the two straights connects the thermosat housing to the steel water pipe that runs round the back of the block.
I am sure the thinner of the two connects the turbo coolant line that runs round the front the block to the water rail banjo.

[GazzaG60]

if like me they don't fit on the car but hang very nicely in a bag in the shed for over 2 years.

[Colesy]

Great, cheers guys.

[UrS4boy]

The fatter of the two straights connects the thermosat housing to the steel water pipe that runs round the back of the block.
I am sure the thinner of the two connects the turbo coolant line that runs round the front the block to the water rail banjo.

Agree, as shown here on an AAN (similar for ABY and ADU etc):

[benntenn67]

The bendy one without bleed nipple - isn't that the rad to header tank one ??