rs2 start problem again

[UrS4boy]

the krang timing calibrate the top of the first piston.is it true?

Yes. The cam to crank timing is based on No.1 (the cylinder at the front of the engine) being at Top Dead Centre (TDC). Some means of checking TDC are shown in this AAN/ABY post: http://forums.quattroworld.com/s4s6/msgs/136943.phtml

Question: Why is your G40 harness connection so far away from where it is supposed to be? As shown here:

[UrS4boy]

Why do the cam wheels have flat teeth ? Are some like that ?

Yes. That is interesting.

This:



Or this (based on a photo from Mcandmar):

[david]

how is it now?

i'm glad you've got it working mate,it was the timing after all
perfect.

[fatiii]

now it is working very well.problem is the wrong socket

thanks again all off for always helping me.

Why do the cam wheels have flat teeth ? Are some like that ?

i do not know it is dbilas

Is it still on a distributor ?

Yes. The cam to crank timing is based on No.1 (the cylinder at the front of the engine) being at Top Dead Centre (TDC). Some means of checking TDC are shown in this AAN/ABY post: http://forums.quattroworld.com/s4s6/msgs/136943.phtml

Question: Why is your G40 harness connection so far away from where it is supposed to be? As shown here:

there is no reason but Is there anything wrong

[jade]

now it is working very well.problem is the wrong socket

thanks again all off for always helping me.




i do not know it is dbilas





there is no reason but Is there anything wrong

Are you sure about the air filter ?

[fatiii]

Are you sure about the air filter ?

no it is temporary for engine break-in time. i will do a new cage later

[UrS4boy]

now it is working very well.problem is the wrong socket.
...there is no reason but Is there anything wrong

Which socket? An electrical connector?

As for the G40 Cam Position Sensor, the factory uses a bracket on the AANs, ABYs and ADUs, near the front of the fuel rail to firmly hold the connector from the cam sensor so it is held firmly, with no banging around, once it is connected to the harness connector. Your's looks like it is hanging loose, with some potential for wires to become fatigued and break.

[fatiii]

Which socket? An electrical connector?

As for the G40 Cam Position Sensor, the factory uses a bracket on the AANs, ABYs and ADUs, near the front of the fuel rail to firmly hold the connector from the cam sensor so it is held firmly, with no banging around, once it is connected to the harness connector. Your's looks like it is hanging loose, with some potential for wires to become fatigued and break.

we have new fuel system and 2 more fuel pump.this system has a little confusion.