vems boost&rpm curve gt3076r

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • quattro-nick
    S2Forum Extremist
    • Sep 2012
    • 1746
    • Country: Belgium

    #1

    vems boost&rpm curve gt3076r

    hi Guys
    i swapping my rs2 turbo for a gt3076r with a/r 0.82 (goal 500hp)
    what is the max boostpressure and redline for this turbo?
    maybe 2.2bar peak and 1.9 bar redline?
    my setup is rebuild AAN with arlows rods and wossner pistons(good for 800hp) cr 8:1so high boost possible and also higher timing maybe?
    the rest is stock head and AAN cams,tubular ex manifold,bosch 044 pump and siemens deka 630cc

    i want to know how high i can fill in my boost&rpm curve from vems so if it's 2.2 bar peak on 4000 rpm then it is 320kpa correct?
    has anyone with about the same setup a vems config for me ?
    the ve table i program with "VE ANALYSER" on the road

    thanks
    nick
    audi coupe quattro b2 2.2 20vt project (573hp-626nm)
    TWINCHARGED power,zero lag
    AEM W/M injection
  • A80Avant
    S2Forum Obsessed
    • Sep 2005
    • 10873
    • Country: Greece

    #2
    I used to have a gt3076. Now slightly different but I also had higher compression and ADU cams. So all in all a rather different setup but I ran 2.1 to 2 bar steady. Your exhaust setup will determine how high boost you can maintain without too high temps

    Comment

    • quattro-nick
      S2Forum Extremist
      • Sep 2012
      • 1746
      • Country: Belgium

      #3
      thanks
      my tubular ex manifold is normal good for around 800hp,downpipe is 3" (76mm) and the rest is fox sport exhaust with 2.75" (70mm) tubes
      have you got a vems file from that you might want to share with me?
      just to compare with mine
      audi coupe quattro b2 2.2 20vt project (573hp-626nm)
      TWINCHARGED power,zero lag
      AEM W/M injection

      Comment

      • A80Avant
        S2Forum Obsessed
        • Sep 2005
        • 10873
        • Country: Greece

        #4
        Send me your email address

        Comment

        • snaak
          S2Forum Enthusiast
          • Jun 2007
          • 153
          • Country: Netherlands

          #5
          I will have one soon, except it is for gtX3076r.
          '95 RS2

          Comment

          • quattro-nick
            S2Forum Extremist
            • Sep 2012
            • 1746
            • Country: Belgium

            #6
            my gt3076r setup is almost compleet but soon i go to start a new thread with pictures of my 500hp project
            audi coupe quattro b2 2.2 20vt project (573hp-626nm)
            TWINCHARGED power,zero lag
            AEM W/M injection

            Comment

            • rnagy86
              S2Forum Buff
              • Mar 2014
              • 47
              • Country: Hungary

              #7
              Here is an old gt3076 VEMS cfg I pulled off from a car. Might help.
              Attached Files

              Comment

              • quattro-nick
                S2Forum Extremist
                • Sep 2012
                • 1746
                • Country: Belgium

                #8
                thanks for sharing!
                audi coupe quattro b2 2.2 20vt project (573hp-626nm)
                TWINCHARGED power,zero lag
                AEM W/M injection

                Comment

                • DJones
                  S2Forum Fiend
                  • Jun 2005
                  • 2020
                  • Country: United Kingdom

                  #9
                  My GT3071.82 did 480bhp at 1.7bar so you should clear 500bhp if the rest of your set up is up to the job...

                  Comment

                  • A80Avant
                    S2Forum Obsessed
                    • Sep 2005
                    • 10873
                    • Country: Greece

                    #10
                    Originally posted by DJones
                    My GT3071.82 did 480bhp at 1.7bar so you should clear 500bhp if the rest of your set up is up to the job...
                    You should stop saying that. Your engine was ultra efficient. Not every car is like that

                    Comment

                    • quattro-nick
                      S2Forum Extremist
                      • Sep 2012
                      • 1746
                      • Country: Belgium

                      #11
                      if I have been on the dyno i will post afterwords the results here and we'll see if my setup is efficient enough
                      audi coupe quattro b2 2.2 20vt project (573hp-626nm)
                      TWINCHARGED power,zero lag
                      AEM W/M injection

                      Comment

                      • DJones
                        S2Forum Fiend
                        • Jun 2005
                        • 2020
                        • Country: United Kingdom

                        #12
                        Originally posted by A80Avant
                        You should stop saying that. Your engine was ultra efficient. Not every car is like that
                        Lol, they should be, that's what we all put the effort in to achieve....

                        Comment

                        Working...