RS2 direct swop injector

[orsum]

Can anybody advise is this injector physically the same as the RS2 injector.

Bosch EV6 440cc Injector

Part number 0280155968

Specifications:
Coil Resistance: 12.5 Ohms / High Impedance / High-Z (No ECM driver modifications required)
Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 42 lb/hr = 440cc/min
Connector: Bosch style connector EV1
Orifice Type: Multi-orifice
Spray Pattern: 30 Degree Spray Cone
Factory fitted with Viton upper and lower o-rings
Length 65mm (60mm O-Ring to O-Ring)

Thanks

orsum

[UrS4boy]

AAN/ABY/ADU fuel injector info

AAN and ABY: Audi PN 034 906 031 B, Bosch PN: 0 280 150 951, flow:
280 cc/ min @ 3.0 bar (= about 26.7 lb/hr at SG = 0.72)
315 cc/ min @ 3.8 bar
323 cc/ min @ 4.0 bar
361 cc/ min @ 5.0 bar

ADU: Audi PN 034 906 031 F, Bosch PN: 0 280 150 984, flow:
360 cc/ min @ 3.0 bar (= about 34.3 lb/hr at SG = 0.72)
405 cc/ min @ 3.8 bar
416 cc/ min @ 4.0 bar
465 cc/ min @ 5.0 bar

More injector info: http://forums.quattroworld.com/s4s6/msgs/20441.phtml

[orsum]

Hi Thanks for the reply.

I am trying to find the physical size of an original S2/RS2 injector vs the one I am looking to buy.

EG seal to seal 60mm and full length 65mm

My main concern is that I do not wish to use adapters or change the connections.

I would like it to be size for size physically, the flow rate does not matter as the ECU will be mapped to suit the flow rate of 440cc.

orsum

[prj]

Plug and play. Might have to trim the grooves slightly for the clips - they are a full circle on the stock injectors and a half-circle on 968's.

[orsum]

Thanks

prj

orsum

[etsola]

Those are the same as Volvo S60R 440cc - I' trying to source them as well

Also in the process in figuring out if the brembo brakes would fit

Let me know if it worked out well for you ?

Thanks