oil leak from front seal

[malncol]

Mal: I think I answered all your questions (and more) in this new post:

http://www.s2forum.com/forum/showthread.php?t=72984

thanks mate thats awesome,what would we do without you
thanks again
mal

[malncol]

fitted new front seal and all is well , wish i could say the same about the 034 steering rack which is toast

[UrS4boy]

fitted new front seal and all is well

Good news. Happy to have helped. Hope your steering rack issue is resolved soon.

[malncol]

The car survived the dyno and had very little coming out the breather but i have a new problem
When you drive the car under heavy acceleration the oil all ends up at the back of the engine and then comes out the block breather
Can i delete the block breather and put a new one out of the rocker cover instead?
thanks
mal

[Error404]

Common problem. There are a few detailed treads on the forum about this, adding a vapour cylone & separator, catch tank etc.
Putting a baffled breather on the top of the rocket cover is a a good solution.

Here is a couple to get you started:

http://www.s2forum.com/forum/showthread.php?t=42864

http://www.s2forum.com/forum/showthread.php?t=47719&highlight=swirl+pot

[malncol]

Common problem. There are a few detailed treads on the forum about this, adding a vapour cylone & separator, catch tank etc.
Putting a baffled breather on the top of the rocket cover is a a good solution.

Here is a couple to get you started:

http://www.s2forum.com/forum/showthread.php?t=42864

http://www.s2forum.com/forum/showthr...ight=swirl+pot

thank you, lots of reading and things to think about there
I think ive fixed it, part of the problem was that i filled the oil level back up to the high tide mark and didnt allow for the 10mm gridle
So effectively over full
also put so stainless mesh in the breather and a T piece so it would if it got high enough drain back to the rocker cover
had a few runs and nothing in the can so far
thanks
mal