Stoker from an AAB?

[pnanassy]

Hi !

I just want to ask,that is it possible to build a Stroker from an AAB bottom end?As i know it is from a 2.4 D T4.

Thanks,
Peter

[porkkis]

It seems to have the oil squirters so why not? Can't imagine a difference between AAB and the turbo diesel blocks.

[caterpillar]

yea! BUT: THE AAB block are only 79,5 bore... 2,5dti are 81mm bore.but the cranck are 95,5 like the AAT 2,5tdi verson;BUT the cranck havent the same P/N....I havent checked out the deckheigth,i think its the same as 2,5tdi...236mm. i have NOT checked out the sylinder THICKNES,may it be thicker than the 2,5tdi.dont know that. i have sutch a engine, i will tell the forum later on about the AAB 2,4 diesel....

[porkkis]

Isn't it just better that it's smaller bore so that it can be bored to factory spec for 81mm pistons? This way it's "new" to start with. I'm almost 100% sure that the cast is the same.