Engine Mounts - ABY

[Rusty]

Are these offset? I have some poly ones to fit and both sides are off by approx 5mm... The poly ones I have are not offset...

[Error404]

The mounting holes on the ABY ones are offset

[rynaqui]

Had changed my mountings and are OEM but there is a lot of drivetrain movement. How do the poly ones fair?

[Rusty]

Arsebiscuits. I have 3B ones then...

[Error404]

Slot the holes?

[Rusty]

I'll have a look. There may not be enough material to do it satisfactorily so may be best to sell on and get some track density or similar.

[_ShurikeN]

Tried expanding front hole, installing non-offset usual right mount in place of offset one. Possible, but not satisfactory indeed. I suspect that may be just impossible with strengthen hard poly-mount.

[Rusty]

Yes, I came to the conclusion that there wasn't really the room to do it properly. I'll swap them out for something else - 034 Track density more than likely - and sell these on, as they fit 3B and S4/6.

[newsh]

Yes, I came to the conclusion that there wasn't really the room to do it properly. I'll swap them out for something else - 034 Track density more than likely - and sell these on, as they fit 3B and S4/6.

I'll buy a pair of 3B mounts off you