As some of you may have seen in my Mental Wheels project thread I bought another RS2 with 'problems'. When the engine came up to operating temperature the oil pressure dropped. The car was sold to me as the previous owner couldn't diagnose the problem whatever he did.
So I took it to Will at VRS who stripped it down and found a banana shaped head with bad valve seats and a head gasket that had gone across all 5 cylinders.




Plus the oil looked like this:

So valve seats were re-cut and head skimmed and engine put back together:

All seemed well, head was perfect - no cracks or anything ...until the oil pressure dropped again
wtf!!!
After another strip down Will discovers this black gasket which doesn't have a hole like the new paper gasket so he thinks he's found the problem,


...only there's no hole on the pump there anyway... wtf... back to the drawing board.
In the end he tries a different pump which for whatever reason seems to work!
I asked what he thought the problem was and he said he thought maybe the tolerances were too tight. These pictures show some wear marks indicating a tight fit, and apparently the inner darker gear is supposed to be slightly proud but was flush with the outer gear:




So anyway, now the thing works it time to see what's what... onto the dyno!!:



It's running rich and was misfiring under load which produced a very squiggled result but the best one knocked out 289bhp, not bad...:

...so hopefully after some fiddling around tomorrow she'll hit the magic 311bhp!!!
In the meantime Kit's going to help me fix the clutch problem in my other green RS2...
So I took it to Will at VRS who stripped it down and found a banana shaped head with bad valve seats and a head gasket that had gone across all 5 cylinders.




Plus the oil looked like this:

So valve seats were re-cut and head skimmed and engine put back together:

All seemed well, head was perfect - no cracks or anything ...until the oil pressure dropped again
wtf!!!After another strip down Will discovers this black gasket which doesn't have a hole like the new paper gasket so he thinks he's found the problem,


...only there's no hole on the pump there anyway... wtf... back to the drawing board.
In the end he tries a different pump which for whatever reason seems to work!
I asked what he thought the problem was and he said he thought maybe the tolerances were too tight. These pictures show some wear marks indicating a tight fit, and apparently the inner darker gear is supposed to be slightly proud but was flush with the outer gear:




So anyway, now the thing works it time to see what's what... onto the dyno!!:



It's running rich and was misfiring under load which produced a very squiggled result but the best one knocked out 289bhp, not bad...:

...so hopefully after some fiddling around tomorrow she'll hit the magic 311bhp!!!
In the meantime Kit's going to help me fix the clutch problem in my other green RS2...
jp said it could be out by 3 thou or more
another rs2 saved



I was *TRYING* to support you against mac2226, if you'd taken the time to notice who I quoted.









Comment