W/I placement of nozzle?

[Jonas_R]

So,

I'm thinking of getting my Aquamist HFS3 installed, but not sure where it whould be smart to place the nozzle?

I was considering placering the noozle in the elbow so it will spray directly towards the throtle body.

[Error404]

I think closer to the intercooler would be better to allow more time for the mixture and evapouration of the water/meth.
If you do put it in intake pipe I would put it at 90deg to the flow so the nozzle doesn't spray directly onto the IAT sensor with the throttle plate open.

[Jonas_R]

I see your point so I guess the bottom of the intake pipe instead.

But would it not be smart to angle the noozle so it doesn't spray directly into the wall of the pipe?

[quattro-nick]

i put mine 90° in the boostpipe before throttlebody

[Error404]

But would it not be smart to angle the noozle so it doesn't spray directly into the wall of the pipe?

Yes but better that than jet into the sensor and have bad IAT readings

[adam g]

If you take a look on the aquarist forum there is a lot of information on pros/cons of jet position

Sent from my D5803 using Tapatalk

[Greg_S]

I mounted mine into the end tank of the inter cooler outlet so it should have plenty of time to mix. Mine is quite a basic setup though so not mapped etc

[Jonas_R]

Sounds like a good spot to fit the nozzle and it will be close to impossible to see which is good ��