Crank pulley bolt torque

[Majorcina]

Hey guys,just to make sure,crank pulley bolt is torqued at 150nm(15kg)+180°?

Послато са G7-L01 уз помоћ Тапатока

[UrS4boy]

Hey guys,just to make sure,crank pulley bolt is torqued at 150nm(15kg)+180°?

Come on Marko. You should have the AAN Shop Manual pdf on your computer by now.

http://s2-audi.co.uk/workshop/aan/aan.pdf

From FredM's timing belt DIY:

36. Install the crank lock. Torque the crank bolt to 338 ft. lbs (458 Nm)
with a 3/4" drive torque wrench or 258 ft. lbs (350 Nm) if you are using the
Audi crank bolt tool.

Here's two detailed ones to use as timing belt guides

http://12v.org/urs/FredMsTimingBeltR&RDIY.pdf

http://www.sjmautotechnik.com/trouble_shooting/S4timing.htm

Here is another one re: 3B in a 200 20VT:

http://www.sjmautotechnik.com/trouble_shooting/eng.html#tim

[Majorcina]

2 days ago my hard disk die and i lost all data i had the strongest tool i found in my country is 200nm(20kg) max,and a friend pull out from etka where it says 150nm+180°. So just wanted to double check before i tight it

Послато са G7-L01 уз помоћ Тапатока

[Rusty]

200Nm + 180 deg is the correct alternative.

Best of luck. I applied my weight at 0.6m and got about 120-130deg. That's about 650Nm...

[LHD_Kid]

200Nm + 180 deg is the correct alternative.

Best of luck. I applied my weight at 0.6m and got about 120-130deg. That's about 650Nm...

You need to eat more pies....

[Majorcina]

Strenth is not an issue So 20kg+180°
Thanks guys

Послато са G7-L01 уз помоћ Тапатока

[blackS2]

I ordered one of those years ago:

http://www.ebay.de/itm/1xRahsol-Dreh...sAAOSwYIhWl3SP

[sam80quattro]

does anybody have the torque setting for an audi aeb (1.8t) just after my last failure I don't want it coming lose... have an arp bolt fitted now but arp claim 140ftlb which seems weak compared to the 5 cylinder setting above???