Seeing as we had a RS2 cross member in today (not every day that happens at £800 each!!), thought I'd snap a couple of pics of it. One interesting thing I noticed when moving it about was that the IC tube inside was loose, IE not fixed and also it was made of plastic!!! Kinda resembles the Plastic top pipe posts a while back about plastic and less heat soak.
-
Last edited by Martynf; 30 October 2003, 23:36. -
: -
-
-
The SFS silicon hose mod would work a LOT better on this than the stock S2 pipe which is curved where the top clip goes. Trouble is, this X member is just way too much money! shame...
MartynComment
-
-
Could you not modify the bracket on your crossmember and send that out by mistake - they would never know
I didn't think mine was plastic - maybe it's just the newer ones?S2,RS2,S4 WB,RS4,S4 B8,RS6 C5,RS6 C6,R8Comment
-
They're not too expensive Martyn
On a more serious note, mine has got the plastic tube instead of metal.
Benthe best intentions are fraught with disappointment - gil grissom
sigpic
1994 ABY Avant - it's getting thereComment
-
:-) could do Doug, but I think QS would notice that!!!
Ben did you wrap yours in suasage foil?
Comment
Comment