I need to replace a brake bulb. How do I remove the interior trim? There are two screws on the latch trim. Do I remove those and unclip the trim ?
-
Alastair
RS2 -
Are you on about a center brake light? if so yes remove the two screws in the handle then peel the panel back. the fasteners let go quite easily, be sure to line them up on refit.
my lhd rs2 only has the usual two brake lights.. accessed through the battery and washer bottle cover...
RobRob..
94 RS2 Noggy,LHD,MTM map,18"cup 1s,245/35/18,Bilsteins,RS2 H&Rs,Cup splitter.
87 UR 20v ABY
97 S6 Avant
96 A6 C4 2.5 TDI quattro avant,Ming,Wietec/eibach,chipped
1967 Ford Mustang,Eleanor,460ci v8 -
GT500 is correct,brake lights on the RS2 are located on the outside lights,not the inside,so there is no need to open the interior trim.Bulbs located there are the rear fog lights and the reverse gear lights.
However removing the trim is as described quite easy.Unscrew the 2 bolts and then gently with a screwdriver unhook each clip from it's securing hole.Comment
-
Yes you are correct and I am going mad SorryAlastair
RS2Comment
-
i think im superior in madness,i unhooked the trim a few months ago to fit foam silencers to reduce bump noises coming from there.I did a really good job might i add!I get no squeeks from my RS2!!! im proud!Comment
Comment