The front and rear bumpers both hang from the wheel well area corners, how are these fixed? Does anyone have any tips before I kneel in the mud to figure it out? : beer:
Announcement
Collapse
No announcement yet.
URS6 Bumper mountings, how are they fixed?
Collapse
X
-
I'm not sure what the coupe ones look like but i've pulled this pic of the net and is the same as mine.
This sits underneath the bumper near the arch. 15217.jpgLast edited by Vorsprung durch Technik; 9 November 2018, 17:56.96 URS6 plus speck saloon
96 URS6 plus speck estate
94 2.6 80 Avant
99 2.8 final edition Cabriolet
Comment
-
As above, you need to push down on the bumper at the wheel arch, whilst pulling outward, this will release the bumper from the two top clips as on the bracket pictured
When the top is released you can lift the bumper out of the single lower clip
One side is a bit more awkward than the other, depending on whether you are left or right handed. But if yours aren't lined up well, it maybe that the brackets are weak so they might come off quite easily
There are two long allen head bolts up in the front bumper, so the two side grills need to come out to access these
For the rear, you need to remove the boot trims to access the 4 main bolts, and then there are some bolts/screws in the wheel well
Front Bumper.pdf Rear Bumper.pdf1989 NG Q Pick-up (Daily)
2002 ASZ Golf (Doris' Daily)
1997 AJK-G2 A6 Avant Q (In surgery)
1999 AGZ Bora (Daily 2)
1994 ABC A6 Avant (Spare)
1984 JS Coupe GT (Slow progress)
1982 WN Coupe GT5 (Spare)
1983 MK1 Golf GTI Pirelli (In storage)
Comment
Comment