Just took my door card off 2 find what was up with my window and found the cable was frayed gunna order a cable set tomorrow just wondered if i have 2 take the whole mechanism out or just the motor and fit the cable with it in place?
-
-
Dan you have to take the regulator assembly out to separate the motor from the cable mech. Unfortunately there is no other way to do this.
Rob. -
ok so 2 get that out there is the 2 bolts at the botom and 2 on each top corner and 3 for the motor yeah?
Then just unplug motor and lift ?Comment
-
Yep, actually one bolt and one nut below that at the top right hand corner (drivers side). Make sure the window is wound down before removing it to make life a little easier for you.Comment
-
ok is there any adjustment needed after
think i will adjust the door while im there seems 2 have dropped a littleComment
-
double post.
Comment
-
You really should adjust the door before aligning the window to the seal. Both of these jobs will drive you to distraction to get them right.
Toptip : use some chalk to mark were the bolts and frame are before you remove them.Comment
-
ok cheers hopefully have the bits wednesday
So wish me luckComment
Comment