Tweet
its around a 10 min job.
Get a non ellipsoid headlight and pop the 7 or 8 metal tabs off and remove the glass (the seal might be stuck on so be gentle)
remove the level adjuster/fixed adjuster and the side repeater bulb
pop off the silver outer section of the light thats just a push on trim
then using a 10mm ratchet with extension start undoing the two adjusters on the back (some are already knackered so a pair of grips to wind them out works)
remove the two spade connectors remembering which way they go
then using a big pair of mole/vice grips pop the plug for the power/etc connector to the light it just twists and goes inwards.
You will be left with
Get a non ellipsoid headlight and pop the 7 or 8 metal tabs off and remove the glass (the seal might be stuck on so be gentle)
remove the level adjuster/fixed adjuster and the side repeater bulb
pop off the silver outer section of the light thats just a push on trim
then using a 10mm ratchet with extension start undoing the two adjusters on the back (some are already knackered so a pair of grips to wind them out works)
remove the two spade connectors remembering which way they go
then using a big pair of mole/vice grips pop the plug for the power/etc connector to the light it just twists and goes inwards.
You will be left with
Comment