I have a Coupe GT and thinking about making it quattro. I know this is possible with rear floorpans from B2/B3 quattro cars, but around here it is easier to get a B4 quattro. Can I use B4 floorpan instead?
-
-
B2 and B3 has almost the same running gear and floor pan. B4 is completely different so it definitely does not fit as is. Of course, you can weld anything to a piece of metal but that's a different story.
1994 Audi 80 Competition -
Right, gonna look for a B2/B3 then. Thank you
Comment
-
Hmmmm. You might want to look at this link,
Comment
-
I have read it, but I am still going to do it most likely.Comment
-
Good, keep us up to date with photos please.Comment
-
I have one rear flor panel from S2 Coupe. And I am also thinking about welding it to B2 CoupeAudi S2 Coupe - parts for saleComment
-
Floorplan
I m doing it soon so will let you know how hard it is as keep getting let down with a early coupe Quattro shell
Comment
-
I am glad to see I am not the only nut case. LOL
Lots of welding. I got stuck with extending the chassis legs to the rear of the car. Later I discovered that the factory just extended the chassis legs across and above the boot floor, leaving a gap between the chassis leg and the boot floor.Comment
-
One more question about the conversion. Is it possible to drill out spotwelds on both cars and weld those or do you have to measure and cut with say plasma cutter?Comment
-
Personally I think it's a bad idea to do it-but good luck with the project.Comment
-
Found an Audi 100 C3 sedan for a cheap buck. I assume I can't use the rear floorpanel on this one?Comment
-
No-one knows about the spotweld/cutting deal?
Comment
Comment