Atermarket fans

[s2driveruk]

in the end just kept the stock fan, isolated the issue to a poor contact on the thermo switch, sings away now as it should

[johne]

On an ABY with the battery under the rear seat, I would take the feed from the back of the alternator, through the relay and onto the fan motor. Shortest route, alternator will be generating some/all of the power (depending on engine rpm) and the feed from the alternator to the battery is already a high current one.

[terrybullwon]

On an ABY with the battery under the rear seat, I would take the feed from the back of the alternator, through the relay and onto the fan motor. Shortest route, alternator will be generating some/all of the power (depending on engine rpm) and the feed from the alternator to the battery is already a high current one.

Thats what i had in mind or the 12v feed to the starter?

But from the loom which feed for the switch on the relay do i use?
The red and black wire that comes from the fan run on, i pressume this is for when the after run system kicks in?
And the other must be one to use? low/medium and high speed all in one? (red and black wire)

This leaves a brown wire only?

Cheers James

[HPmuirt]

I just put RS2 fan. Flows like hurricane.

Albert, I thought the ABY and RS2 fans were the same

Or are you talking about going from the 300W 3B fan to the ABY/RS2 500W fan?

Cheers n

Si

[terrybullwon]

Albert, I thought the ABY and RS2 fans were the same

Or are you talking about going from the 300W 3B fan to the ABY/RS2 500W fan?

Cheers n

Si

You got it Si

[Flat on my back]

Perma-Cool fan.

Been looking at these to replace my current fan (7A engine bay), nothing wrong with the fan except I’m desperate to free up some space to fit a catch tank.

Any recommendations on the model to go for?