You can change the style the forum displays by selecting your preferred style at the bottom left of the site.
We have made an enhancement so that old threads should now link from search results to the correct thread. This is not yet in place for single post links
It's absolutely spotless. I've had the same guy do my bike frames. In the last with other coaters they end up full of sand in threads inside tubes etc.
Everything I have had done with this guy is spotless.
Yeah I've had a few 80s rare BMX bike frame/forks stripped and the attention to detail. Eg masking or bunging threads or taping off mounting faces .I've had frames done elsewhere and had to spend an age tapping threads.
I replaced my knock sensors too. Water rail seals and tidied up the wiring . I even fitted my last two silicone breather hoses and vac hoses.
i can't wait to start her up..
Anyone know the size and thread pitch for these holes? my threads have been marred a bit and id like to get them cleaned up before i install the new seats.
Anyone know the size and thread pitch for these holes? my threads have been marred a bit and id like to get them cleaned up before i install the new seats.
Sorry, I don't know. Can you not get a thread gauge on one of the new seats to find out?
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment