Originally posted by The Spanish
Great car Mate.
I am very interested on your rear brakes setup.
How did you get the RS2 hubs to fit to the rear?
I have been thinking a lot about it.
I also have RS2 wheels front and back, but only RS2 hubs front.
My temporary solution for the rear is using H&R adaptors from AUDI to PORSCHE wheels.
Info here: http://www.s2forum.com/forum/showthr...&threadid=1871
Can you give me info on this please?
Rafael
Great car Mate.
I am very interested on your rear brakes setup.
How did you get the RS2 hubs to fit to the rear?
I have been thinking a lot about it.
I also have RS2 wheels front and back, but only RS2 hubs front.
My temporary solution for the rear is using H&R adaptors from AUDI to PORSCHE wheels.
Info here: http://www.s2forum.com/forum/showthr...&threadid=1871
Can you give me info on this please?
Rafael
Here are a couple of photos of the modified hub. It's machined out to accept an RS2 wheelbearing, and have been added with a ring of metal so outside diameter is same as RS2 hub. It's also been machined to make a flat surface to attach the RS2 "backplate" to. Here you must measure the distance from bearing to surface on the RS2 hub and make the same distance from bearing to machined surface on the S2 hub. (Did that make sence to anybody but me ) A bit difficult to explain, but hope the pictures gives an idea of what have to be done.
NB! The calippers have to be in the S2 position and not as on the RS2. Because of this you have to move the bleeding to the other end of the calippers.
Cheers,
Roger
Comment