EGT & WB O2 Sensors & Gauges

[Rusty]

Zeitronix is about the same price, $500 for the WB O2, EGT and a dial gauge or readout.

[Jonas_R]

Here you go:



Zt-2 + ZR-1 Blue Digits AFR and Lambda Gauge Combo which is the Middle Gauge, the O2 sensor and the Zt-2 datalogger system. 379$
I bought the VDO turbo boost gauge for 25$ from summitracing
Bought the EGT gauge from summitracing with EGT probe for 100$ Linky

Then I have also bought a mapsensor from Zeitronix and and extension wire, so that I can datalog EGT, boost, RPM, Lambda

[Rusty]

Cheers. I was also looking at the readout they do, that would fit in there just nice I think. 4.7" x 2"

[quattro20v]

Vems shop say that it is 249.70e

Also i have driven with the wideband connected to motronic, it's just a little on the rich side and it's not so smooth to drive as the original lambda.

http://shop.vems.hu/catalog/product_info.php?cPath=1&products_id=101&osCsid=99c121060179a82d0d9004082d429126

[terrybullwon]

From where mate

From me, Let me see what i can do

If your sure you want one?

There is a picture in my project thread of it fitted in the center.

[AndyP]

From me, Let me see what i can do

If your sure you want one?

There is a picture in my project thread of it fitted in the center.

I'd be interested in a thermocouple if you can get more.

[Rusty]

Not in a position to buy just yet as I'm still off work, when I'm back I'll be looking for a few toys

[JRedig]

Cheers. I was also looking at the readout they do, that would fit in there just nice I think. 4.7" x 2"

IMO, that display is much bigger than it needs to be. The actual screen is much smaller than the case it's in and fitting it is difficult. It looks great but is hard to read in certain light too. I much prefer their round guages.

[s2_southwest]

From me, Let me see what i can do

If your sure you want one?

There is a picture in my project thread of it fitted in the center.

Terry, i would be very interested depending on what cost you can get one for.

[Greg_S]

£15 for a K-type termo couple, and the £150 includes the WB O2 sensor, which is a bosch part.

Id be interested in a K type thermocouple since current one is dead

[merlin's S4]

Id be interested in a K type thermocouple since current one is dead

Me too actually! And possibly the Wideband too.

[terrybullwon]

I have asked for a price to put up to the forum from dnb, Farnell Online is the cheapest source for most K type thermocouples. I think that you need to be looking at 5mm for the turbo because it's a bit hotter than NA, but 3mm would work without a problem though. But minmum order is £20 iirc.

[Greg_S]

Yeah I use to get them from farnell before and order a few each time

[AndyP]

James

Did you get anywhere with these? If not could you give me a clue which one to order from Farnell, these hundreds of them on their site!

[quattronutter]

im running a plx digital gauge in my s4,i customised the rear view mirror to house the gauge,i can read egt's,boost pressure,afr and all available obd data,an also data log and set warning parameters