316 had a bad name at one point as it's the grade powerflow used and their variant rusted to f**k! I've seen others that are fine.
Looks spot on btw.
-
Sorry that's what I mean't
316 had a bad name at one point as it's the grade powerflow used and their variant rusted to f**k! I've seen others that are fine.
Looks spot on btw. -
304 is better for heat tolerance, 316 is technically a better grade but Jamo is correct. I have stacks of 304 and some 316 bends but the 304 is going at the hot end!Martin Cutting
aka Keeper of "The Teutonic Kitten"
It's not better than sex, but it runs it a close second.Comment
-
.
if the '316' had a bad name at one time...then it wasn't '316' !
316 is good shjt...but very hard to cast, machine or weld properly...woudln't use it for an exhaust though.Carlos.
On the look out for less bits for my s2 saloon project. Now supporting myself by shooting for my food. www.airgunforum.co.ukComment
-
I have seen some exhaust makers banging on about inferior 316 which is an inaccurate statement, but that's probably because the people involved were told by someone else.
In fact, SS321 is far better than both but it is a total b*****d to get as preformed bends.Martin Cutting
aka Keeper of "The Teutonic Kitten"
It's not better than sex, but it runs it a close second.Comment
-
Who made it then? someone in Lincoln?Comment
-
We all know who did it, do we have to go there?Comment
-
How much was it?Comment
-
Budget on a 'bag of sand' and you'll not be far wrong
sigpic
1991 Audi S2 3B - 2.5 Stroker engine
1997 A6 2.5TDi quattro avant - C4
1976 RD250E / 350LC cafe racerComment
-
thats complete & fitted as well??...Comment
Comment