Aluminum MAF housing

[terrybullwon]

it needs to be alu so it can be welded into the intake track for a totally sealed system using wiggins fittings to couple at the turbo, intercooler and throttle housing.

[Losgard]

Uhm okey, weld the maf for absolute no leak on the non-presure side of the turbo?

[fish]

No, it was´nt that one i ment. I have een them in flesh when i was at his place a few weeks ago. i´ll try and dig a pic out of one.

[terrybullwon]

Uhm okey, weld the maf for absolute no leak on the non-presure side of the turbo?

Yes, But both sides. Pressure and non pressure using wiggins fittings like this

No, it was´nt that one i ment. I have een them in flesh when i was at his place a few weeks ago. i´ll try and dig a pic out of one.

cool

[terrybullwon]

can any one link me to the thread where its shown how the maf comes to bits?

[twoqu]

This might be useful!

http://www.s2forum.com/forum/showthread.php?t=5724&highlight=carbon+maf

Well the first bit at least!